Skip to content
AW
Arifah Whitlam

Anker SOLIX C1000 Gen 2 Review

Anker SOLIX C1000 Gen 2 review: 1,024Wh, a 2,000W inverter and a 49-minute wall recharge in 24.9 lb, but no expansion port and loud fans.

  • 2,000W continuous / 3,000W peak output (Anker's rating), the highest in the 1kWh group we've covered so far
  • Five 120V AC outlets, two 140W USB-C, one 15W USB-C and one 12W USB-A, so ten outputs in all counting the car port
  • Anker quotes a 49-minute full recharge from the wall with UltraFast Charging switched on (1,600W input); MacRumors' reviewer also got a full charge in 49 minutes
  • UPS switchover rated at 10ms, quicker than the 20–30ms of the EcoFlow, Jackery and Bluetti units on this site
  • LiFePO4 cells rated by Anker for 4,000 cycles to at least 80% capacity
  • Up to 600W of solar input (60V max), more than most single-battery 1kWh rivals accept
  • No expansion battery port. Anker's own comparison table lists expandable capacity as 'No', so 1,024Wh is all it will ever hold
  • The original C1000's built-in LED light bar is gone, which you'll notice the first time the power cuts out after dark
  • Fans are quiet at light loads but loud during fast charging or heavy draw; Notebookcheck measured roughly 45 dB at 1 meter
  • The five AC outlets sit close together, so a fat plug or wall-wart adapter can block its neighbor
  • Street price swings a lot (about $349–$379 in late-2025 sales, higher at other times), so the deal you see may not last
  • Like any portable station, it can't feed your home's circuits unless a licensed electrician installs a transfer switch or inlet

Suppose you’ve already priced the EcoFlow DELTA 2, the Jackery Explorer 1000 v2 and the Bluetti AC180, and you’ve noticed each one makes you give something up. The Jackery is light but has three outlets. The Bluetti has the outlets but weighs as much as a bag of mortar mix. The DELTA 2 is cheap now because it’s on its way out. The Anker SOLIX C1000 Gen 2 is the unit that looks, on paper, like it doesn’t make you give anything up.

That’s mostly true. The trade-off it does make is one you might not notice until a year from now: you can’t add battery to it, ever. Whether that matters decides whether this is the one to buy.

A note on how this review was put together. I haven’t run this unit on my own bench. Specs below come from Anker’s product page. Real-world behavior, like noise, charge time and how it handled loads, comes from published hands-on reviews by MacRumors, Notebookcheck, CleanTechnica and The Gadgeteer, and I say which source each number comes from. Prices and warranty terms change often, so check them before you buy.

How it stacks up against the 1kWh units you’re probably comparing

This is the shortlist most people end up with when they want something that runs a fridge through an overnight outage, then rides in the truck to a campsite in summer.

Anker C1000 Gen 2 EcoFlow DELTA 2 Jackery 1000 v2 Bluetti AC180
Rated capacity 1,024Wh 1,024Wh 1,070Wh 1,152Wh
Continuous AC output 2,000W 1,800W 1,500W 1,800W
AC outlets 5 6 3 4
Max wall charging 1,600W (UltraFast) 1,200W ~1 hr in emergency mode 1,440W
Max solar input 600W 500W 400W 500W
UPS switchover 10ms up to 30ms ≤20ms 20ms
Weight 24.9 lb ~27 lb ~23.8 lb ~35 lb
Expansion battery No Yes No Yes

Manufacturer ratings as listed in October 2026. Check current listings, since manufacturers revise these.

Line them up and the Anker wins on output, solar input and switchover speed, and it’s second-lightest. It ties the Jackery for having no expansion option at all. The DELTA 2 and AC180 both let you bolt on a second battery later.

The two numbers that earn the price: output and switchover

2,000W in a 25-pound box

From a contractor’s point of view, the 2,000W continuous rating is what moves this unit from “camping battery” toward “jobsite helper”. A 15-amp circular saw, a small air compressor kicking on, an electric kettle at the campsite: those are the loads where 1,500W stations trip and shut down. MacRumors ran it at 1,500W without trouble and ran a 750–1,500W space heater for about an hour. That hour is honest, and it’s the right way to think about resistive heat: a battery this size is not a heating plan.

Don’t confuse the inverter rating with stamina, though. At 2,000W you’re draining a 1,024Wh pack in well under half an hour once you account for inverter losses. The big output is for starting hard loads and running short bursts, not for running a window AC all afternoon.

10ms is the spec I’d actually pay for

The other three units on this site quote 20–30ms switchover. Anker says 10ms. Here’s why that matters for a home setup. When you leave the station plugged into the wall with your modem, router and a few lights behind it, the switchover gap decides whether an outage is something you notice or something that reboots your network gear and your doorbell camera. Most network gear rides through 20ms fine. A desktop PC with a marginal power supply sometimes won’t, and 10ms gives you more room.

It still isn’t a true online UPS, which has zero transfer time because the load always runs from the inverter. If you have a NAS or a workstation you really care about, pull the wall plug on purpose some weekend and watch what happens before a storm does it for you.

Charging: fast, but read the toggle

Anker’s 49-minute full charge needs UltraFast Charging switched on in the app, which raises the input to 1,600W. Out of the box it charges at about 1,200W. MacRumors’ reviewer also recorded 49 minutes and said the default draw was about 1,200W. That suggests the time depends on the state and settings of the unit, so expect anything from under an hour to roughly an hour and a half.

There’s a practical catch that spec sheets skip. Pulling 1,600W from one wall receptacle uses most of a standard 15-amp household circuit (about 1,800W). If that receptacle shares a circuit with a microwave or a space heater, you’ll trip the breaker. Use the slower default if you’re charging from a garage outlet with other things on it, and save UltraFast for a dedicated or lightly loaded circuit.

Solar input tops out at 600W, with a 60V maximum. That’s generous for this size class. Two 300W panels wired within the voltage limit can, on a good day, roughly refill the battery between late morning and mid-afternoon. Check your panels’ open-circuit voltage in cold weather before you wire them in series. Voltage rises as temperature drops, and that’s the most common way people overshoot an input limit.

The parts that undercut it

No expansion port

This is the big one, and it’s a deliberate step backward from the original C1000, which took Anker’s BP1000 expansion battery. Anker’s own Gen 2 page lists expandable capacity as “No”. To make it more confusing, the same page shows expansion bundles that apply to the first-generation C1000. Read the model name on the listing carefully.

In practice, about 1kWh covers an overnight fridge-plus-router outage or a long weekend of camp lights, phones and a 12V cooler. It does not cover a two-day outage with a chest freezer running. If you live where outages run longer than a night, you either buy a second unit later or start with a station that accepts an add-on battery.

The light bar is gone

The original C1000 had a built-in LED light bar. The Gen 2 doesn’t. The Gadgeteer’s only real complaint was the missing light, and I agree with them for a dull reason: the first five minutes of an outage happen in the dark. Keep a headlamp or a USB lantern strapped to the handle and the problem goes away, but it’s one more thing to remember.

Fan noise under load

Anker advertises operation as quiet as 20 dB, and that’s a light-load figure. Notebookcheck measured around 45 dB at 1 meter during high output and fast charging, and MacRumors said the fans would keep them from sleeping nearby. Charging phones or running a CPAP-sized load stays quiet. Fast-charging from the wall or running a kettle does not. If it lives in a bedroom during an outage, turn off UltraFast and keep the load light at night.

Tight outlet spacing

MacRumors flagged the five AC outlets as crowded, and anyone who has fought a power strip knows the problem. A fat transformer plug or a right-angle extension cord can cover the next outlet. Five outlets in theory might be four in practice. A short 1-foot extension “pigtail” for each bulky plug solves it for a few dollars.

App-first design

The app is good. It works over Wi-Fi or Bluetooth, shows live draw and time remaining, and sets charge and discharge limits and time-of-use scheduling. But some useful settings only live there, including UltraFast charging. MacRumors also reported a firmware update that failed for several days before it finally went through. Set the unit up, update the firmware and set your limits before storm season, not during it.

Safety and installation notes

  • Home wiring needs an electrician. You can run appliances from the station’s outlets with extension cords. Connecting it to your panel requires a properly rated transfer switch or power inlet installed by a licensed electrician. Never backfeed through a dryer receptacle or a “suicide cord”. It can energize the utility line a lineworker is touching.
  • Ventilation and placement. Keep the side vents clear and run it on a hard, dry surface, not on carpet or a truck-bed liner in direct sun. Follow Anker’s manual for operating and charging temperatures. LiFePO4 is more stable than older lithium chemistries, but no battery likes heat.
  • No air travel. At over 1kWh it’s far above airline lithium battery limits.
  • Storage. MacRumors left it fully charged and off for a month and found it still at 100%. That’s good for an emergency unit sitting in a closet, but top it off every few months anyway.

Price and warranty, as of this writing

In late-2025 coverage it sold for about $379 on Anker’s own store and $349 on Amazon, and MacRumors called its $372 price “more than half off its MSRP”. Prices on these stations move with every holiday sale, so treat those as a reference, not a promise. The current price on Anker’s site or a major retailer is the only one that counts.

The user manual and authorized resellers list a 5-year warranty, with terms on the card in the box. Anker’s product page itself just says “Hassle-Free Warranty”. Before you pay, confirm the term applies to the listing you’re buying, because open-box, refurbished and third-party marketplace units don’t always carry the same coverage. Register the unit when it arrives and keep the receipt with the manual. That’s the paperwork any warranty claim will ask for.

Who should buy it, and who shouldn’t

Buy it if:

  • You want the most output and fastest recharge in a box you can still carry one-handed from the garage to the truck.
  • Your outages usually last hours, not days, and about 1kWh covers your fridge, router and lights overnight.
  • You’ll use it on jobsites or at campsites with bursty loads like a saw, a compressor or a kettle, where a 1,500W inverter would trip.
  • You want the shortest switchover in this group for network gear plugged in behind it.

Skip it if:

  • You think you’ll want more battery later. The DELTA 2 or Bluetti AC180 let you grow; this doesn’t.
  • It will run near where people sleep and you need fast charging. The fans are the weak spot.
  • You want a light built into your emergency box. The original C1000 still has one, along with expansion support, while stock lasts.

My take: the C1000 Gen 2 is the best-specified 1kWh station we’ve looked at, and the 10ms switchover is the spec I’d value most for a home setup. The missing expansion port is the price of the lighter, punchier box. Decide now whether 1kWh is enough, because you can’t change your mind later without buying a second unit.

Common questions

The original C1000 has a 1,056Wh pack, an 1,800W inverter, a built-in LED light and a port for the BP1000 expansion battery. The Gen 2 drops to 1,024Wh but raises output to 2,000W, charges faster, weighs less at 24.9 lb, and loses both the light and the expansion port. Pick the Gen 1 if you want to add capacity later, and the Gen 2 if you want more output and speed in a lighter box.

TheYardKit may earn a commission if you buy through links on this page — it never changes a verdict. Follow the manufacturer's safety instructions for fuel, electrical, battery and cutting equipment.

More from the shed